 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
Services
Service and Labor Rates for Vintage Vespa Motor Scooters.
ALL SERVICE IS BY APPOINTMENT ONLY
General Labor Shop Rate $45/hr
"I Can't Wait" Rate $100/hr
Minimum Labor Charge - $35.
The following are estimated costs for usual services.
Tip: Usually a clean scooter is easier to work on and takes less time to fix.
Oil Change- $25 including oil
This should be done at least once a year. I recommend having this done at the end of the
riding season before you store it for the winter. While the oil is draining I'll give your scooter a
quick look over.
Carburetor Rebuilds: This is the place to start when trying to get your scooter running in top
condition. A dirty gummed up carburetor will affect fuel flow and the scooter will never run right.
I completely disassemble and inspect your carburetor, clean the carburetor and passage ways
then re-assemble. I replace the float, float needle, and all gaskets. I inspect all the jets to insure
clean and clear of debris. Any part that is found to faulty will be replaced. The price of a rebuild
varies on the carburetor.
Basic tune-up: $179
This is where to start with a scooter that hasn't been running in a while. The gas tank and fuel
tap are checked to make sure they are in shape and providing fuel to your carburetor. The
carburetor is cleaned and rebuilt. All cables are adjusted. The gear oil and spark plug are
replaced. The tire pressure and tire wear is checked. Suspension, brakes and lighting is
checked. The scooter is given a test ride to make sure everything is in good working order.
The customer will be called and given an cost estimate if any additional work is recommended or
required.
Complete Engine Rebuild 60's - 80's models - $500 ,
In a complete rebuild, the engine is disassembled and all parts are cleaned and inspected. Any
part not listed below that is found to be worn or not serviceable is identified at this time. The
customer is informed what the additional charge will be to replace the worn part. The carburetor
is cleaned and rebuilt. Piston to cylinder wall clearance is checked. Exhaust port, piston, and
cylinder head are decoked. Engine is assembled using new hardware.
The following parts are replaced:
Bearings
Seals
Gaskets
Piston Rings
O-rings
Clutch Corks, Bushing and Actuating Pad
Cruciform
Kickstart Gear
Kickstart Buffers
Brake Shoes
Spark Plug
Points
Condensor
Coil (if necessary)
Carburetor Gaskets
Float needle
Float
If your engine is brought in dirty there will be a $45 cleaning fee.
Clutch Rebuild- The clutch is disassembled and parts are inspected for wear. The Clutch Corks,
Bushing and springs are replaced. Any additional necessary parts are replaced.
$170
Top End Rebuild - Cylinder head, cylinder, piston are removed to renew piston rings or
complete piston assembly. Cost for cylinder honing or oversizing not included.
$155
Cable Service
Having trouble shifting or braking? Snap a cable and can't seem to get a replacement
fed-through? Bring your bike in and one of our Cable Technicians will have you
properly-adjusted and on your way in short order.
Inner Cable Renewal
1 inner - $35
2 inner - $70
3 or all inner - $95
Complete Cable Renewal
1 complete - $60
2 complete - $85
3 or all complete - $130
Tire Change
One Tire - $35
Two Tires - $65
Brake Shoe Renewal
Front OR Rear - $35
Front AND Rear - $70
ALL SERVICE IS BY APPOINTMENT ONLY
General Labor Shop Rate $45/hr
"I Can't Wait" Rate $100/hr
Minimum Labor Charge - $35.
The following are estimated costs for usual services.
Tip: Usually a clean scooter is easier to work on and takes less time to fix.
Oil Change- $25 including oil
This should be done at least once a year. I recommend having this done at the end of the
riding season before you store it for the winter. While the oil is draining I'll give your scooter a
quick look over.
Carburetor Rebuilds: This is the place to start when trying to get your scooter running in top
condition. A dirty gummed up carburetor will affect fuel flow and the scooter will never run right.
I completely disassemble and inspect your carburetor, clean the carburetor and passage ways
then re-assemble. I replace the float, float needle, and all gaskets. I inspect all the jets to insure
clean and clear of debris. Any part that is found to faulty will be replaced. The price of a rebuild
varies on the carburetor.
Basic tune-up: $179
This is where to start with a scooter that hasn't been running in a while. The gas tank and fuel
tap are checked to make sure they are in shape and providing fuel to your carburetor. The
carburetor is cleaned and rebuilt. All cables are adjusted. The gear oil and spark plug are
replaced. The tire pressure and tire wear is checked. Suspension, brakes and lighting is
checked. The scooter is given a test ride to make sure everything is in good working order.
The customer will be called and given an cost estimate if any additional work is recommended or
required.
Complete Engine Rebuild 60's - 80's models - $500 ,
In a complete rebuild, the engine is disassembled and all parts are cleaned and inspected. Any
part not listed below that is found to be worn or not serviceable is identified at this time. The
customer is informed what the additional charge will be to replace the worn part. The carburetor
is cleaned and rebuilt. Piston to cylinder wall clearance is checked. Exhaust port, piston, and
cylinder head are decoked. Engine is assembled using new hardware.
The following parts are replaced:
Bearings
Seals
Gaskets
Piston Rings
O-rings
Clutch Corks, Bushing and Actuating Pad
Cruciform
Kickstart Gear
Kickstart Buffers
Brake Shoes
Spark Plug
Points
Condensor
Coil (if necessary)
Carburetor Gaskets
Float needle
Float
If your engine is brought in dirty there will be a $45 cleaning fee.
Clutch Rebuild- The clutch is disassembled and parts are inspected for wear. The Clutch Corks,
Bushing and springs are replaced. Any additional necessary parts are replaced.
$170
Top End Rebuild - Cylinder head, cylinder, piston are removed to renew piston rings or
complete piston assembly. Cost for cylinder honing or oversizing not included.
$155
Cable Service
Having trouble shifting or braking? Snap a cable and can't seem to get a replacement
fed-through? Bring your bike in and one of our Cable Technicians will have you
properly-adjusted and on your way in short order.
Inner Cable Renewal
1 inner - $35
2 inner - $70
3 or all inner - $95
Complete Cable Renewal
1 complete - $60
2 complete - $85
3 or all complete - $130
Tire Change
One Tire - $35
Two Tires - $65
Brake Shoe Renewal
Front OR Rear - $35
Front AND Rear - $70
